RADEMACHER RolloPort S2, Перевод оригинального руководства по эксплуатации и сборке

Страница: 26 / 36

Automatic closing time setting
5. Press „+“ and select
the required closing time:
1 = 30 sec.
2 = 60 sec.
3 = 90 sec.
4 = 120 sec.
6. Press „P“ in order
to store the setting.
5 = 150 sec.
6 = 180 sec.
7 = 210 sec.
8 = 240 sec.
(maximum)
7. Conclude programming
(refer to page 27,
method 2)
or
proceed with the next
setting.
After a period of time in use, regularly
check to see whether the door is level when
opening/closing, and whether the spring has
enough force to raise the door.
Add a suitable amount of lubricant to all
moving parts regularly.
2. Press „+“
(press several times if necessary)
until „7“ is displayed.
2000 cycle alarm setting
3. Press „P“,
the display is „0“.
(0 = off = factory setting)
4. Press „+“,
the display is „1“.
(1 = on)
NOTE
If this function is activated, after 2000 cycles the door
operator will indicate with a short whistling tone at regu-
lar intervals that door maintenance must be carried out.
To end the alarm tone
Switch the power supply off and then on again, or press
the „ P “ button for the door for 5 seconds.
5. Press „P“ in order
to store the setting.
6. Conclude programming
(refer to page 27, method 2)
or proceed with next setting.
1. Press „P“ for
approx. 5 seconds.
26
EN