10
5. Computer presets
5.1. Software installation
To install “
Prism2
” Package on the hard disk of the computer please follow the
next steps:
Plug the USB flash drive to the computer's USB port.
Wait while drive automatically recognized by the Windows and adds it to the
computer's drivers list as a virtual hard disk.
Windows will prompt you to open the contents of the drive in Explorer, open
Explorer and run the Setup program by its double-clicking.
If autorun is disabled, then click the Start button on the tray and then Run (if your
Windows does not have a the Run item in the Start menu, you is able to open the
Run window by pressing Windows Key
+ R), type d:\setup in the Open line of
the window Run, where d is the letter of the USB flash drive, and then click OK.
Follow the installation instructions. The activation code is sticked on the USB flash
drive envelope. You can also receive an activation code by email.
Run the “
Prism2
” software.
5.2. Computer configuration for Ethernet cable connection with the GPR
control unit
The “Zond-12e Advanced” GPR (from the serial number 0537) and “zGPR”
family units are equipped by a built-in wireless router, that automatically configures
the TCP / IP settings of user’s PC
(TCP/IP settings have to be set to “Obtain an IP
address automatically”).
For “
Zond-12e Single Channel
”, “
Zond-12e Double Channel
”
or earlier versions of “
Zond-12e Advanced
” GPR or if the user, for any reason, has
changed the
Local Area Connection
settings, user has to configure manually PC settings
for the connection with the GPR. To do so, please follow the next steps:
For
Windows XP:
1.
Click the
Start
button, point to
Settings
and then click
Control Panel
.
2.
Double click the
Network connections
icon.
3.
Double click your
Local Area Connection
icon and then click
Properties
button.
4.
Select
Internet protocol [TCP/IP]
and click the
Properties
button.
5.
For
GPRs manufactured after 2015
- click the
Obtain an IP address
automatically
option and continue from the point
9.
6.
For
GPRs manufactured before 2015
- click the
Use the following
IP
address
option.
7.
Click the
IP Address
box and enter
192.168.0.2
(if this address is occupied or
is not accessible, you could use any address from 192.168.0.2 to 192.168.0.254,
except occupied address 192.168.0.10.
Please, consult with your network
administrator before changing IP addresses
).
8.
Click the
Subnet mask
box and enter
255.255.255.0
.
9.
Press OK button.
10.
Press
Close
button.
