W W W . R A D P O W E R B I K E S . C O M
19
o
If the hub and bottom bracket bearings have been submerged in water they should be taken out and re-greased. This
will prevent accelerated bearing deterioration.
o
If the paint has become scratched or chipped in the metal, use touch up paint to prevent rust. Clear nail polish can
also be used as a preventative measure.
o
Regularly clean and lubricate all moving parts, tighten components and make adjustments and required.
Safety Checklist
Notice:
Before every ride it is important to carry out the following safety checks.
Safety Check
Basic Steps
1.
Brakes
o
Ensure front and rear brakes work properly.
o
Ensure brake pads are not over worn and are correctly positioned in
relation to the rims.
o
Ensure brake control cables are lubricated, correctly adjusted and
display no obvious wear.
o
Ensure brake control levers are lubricated and tightly secured to the
handlebars.
2.
Wheels and Tires
o
Ensure tires are inflated to within the recommended limits displayed on
the tire sidewalls.
o
Ensure ties have tread and have no BULGES OR EXCESSIVE WEAR.
o
Ensure rims run true and have no obvious wobbles or kinks.
o
Ensure all wheel spokes are tight and not broken.
o
Check axle nuts and quick releases to ensure they are tight. If your
bicycle is outfitted with quick release axles, ensure the locking levers are
correctly tensioned and in the closed position.
3.
Steering
o
Ensure handlebar and stem are correctly adjusted and tightened, and
allow proper steering.
o
Ensure the handlebars are set correctly in relation to the forks and the
direction of travel.
4.
Chain
o
Ensure the chain is oiled, clean and runs smoothly.
o
Extra care is required in wet or dusty conditions
5.
Bearings
o
Ensure all bearings are lubricated, run freely and display no excess
movement, grinding or rattling.
