RACOM RipEX 1.6.0, Руководство пользователя

Страница: 97 / 171

Note: It is possible to put RipEX into SAVE state anytime using the respective CLI command
○ Reset timeout on received packets
List box: On, Off
Default = Off
If “
On ”, the “Timeout from wake-up” is reset whenever a packet is received or transmitted over
the Radio channel channel by the RipEX in the ACTIVE state. Consequently the RipEX stays
in the ACTIVE state as long as it communicates over the Radio channel channel.
Note:
HW wake-up
With any fw version higher than or equal to 1.2.1.0 you can take a RipEX in Save state, cycle
the power and during the boot-up (approx. 25 sec.) the LED Status starts to flash quickly in
green for approx. 10 sec. When Reset button is pressed for approx. 1 sec. during that period of
quick blinking, the Power supply mode is set to Always On and the unit can be accessed in the
usual way (Ethernet or “X5” USB/ETH adapter)
• Sleep Mode
Sleep Mode is controlled via the digital input on Power and Control connector. When the respective
pin (SI) is grounded, RipEX goes to sleep and consumes only 0,07W. The time needed for a complete
wake-up from the Sleep mode is approx. 25 seconds (booting time).
○
Timeout from sleep request [s]
Default = 10
RipEX remains On for the set time from the moment when the sleep input pin has been grounded.
When SI pin on Power and Control connector is not-grounded for 1 sec. (or more) during this
Timeout, the timeout is reset and starts again.
Note: when Hot Standby is “On”, Save and Sleep modes are not available.
Wifi
List box: Off, On
Default = On
When “On”, RipEX management can be executed over WiFi using the W1 - WIFI/USB adapter from
RipEX accessories. This equipment must be plugged into RipEX USB interface. You just switch on
WiFi in your device (notebook, tablet, smartphone…) and connect it to the RipEX WiFi network. Your
device will get its IP settings from the RipEX builtin DHCP server. Then type https://10.9.8.7 in your
browser address line and you will be connected to RipEX web pages.
Note: DHCP in the W1 - WIFI/USB adapter provides max. 5 leases, so up to 5 devices can be connected
to one RipEX via WiFi.
• Parameters
List box: Default, Manual,
Default = Default
Default – Default (recommended) values are set and can not be edited.
Manual – Values can be set manually.
○ SSID
Default = RipEX + Unit name + S/N
An SSID (Service Set IDentifier) is a unique ID that consists of max. 32 characters and is used
for naming wireless networks. When multiple wireless networks overlap in a certain location,
SSIDs make sure that data gets sent to the correct destination. If empty, default value is filled.
○ IEEE standard
There are different standards used for WiFi networks. RipEX supports some of them.
List box: possible values
Default = 802.11g
97 © RACOM s.r.o. – RipEX Radio modem & Router
Advanced Configuration