RACOM RipEX 1.6.0, Руководство пользователя

Страница: 45 / 171

1 2 3 4 5 6 Pin No.: 7
SI AI - + A0 +
-
10–30VDC
Fig. 4.8: Supply connector
Wire
Ports (7)
Retaining
Screws (2)
Lead
Binding
Screws (7)
Fig. 4.9: Power and Control - cable plug
1 2 3 4 5 6 Pin No.: 7
SI AI - + A0 + -
10–30VDC
Sleep Input
SLEEP INPUT
SLEEP INPUT is the digital input for activating the Sleep mode.
When this pin is grounded (for example when connected to pin
3), the RipEX switches into the Sleep mode. Using Power man-
agement (
Advanced Config. ), the Entering the Sleep mode can
be delayed by a set time. Disconnecting SLEEP INPUT from
GND (-) ends the Sleep mode. Note that RipEX takes 25 seconds
to wake up from the Sleep mode.
SLEEP INPUT can be also used for the wake-up from the Save
state. For details see chapter (
Advanced Config. , Power manage-
ment)
1 2 3 4 5 6 Pin No.: 7
SI AI - + A0 + -
10–30VDC
Alarm Input
HW ALARM INPUT
HWALARM INPUT is a digital input. If grounded (e.g. by connect-
ing to PIN 3), an external alarm is triggered. This alarm can be
used for example to transmit information using SNMP trap, in-
forming for instance about a power outage or RTU problem. For
details about Alarm management see chapter
Advanced Config-
uration .
1 2 3 4 5 6 Pin No.: 7
SI AI - + A0 +
-
10–30VDC
Alarm Output
max. 30 V DC, 1 A
HW ALARM OUTPUT
HW ALARM OUTPUT is a digital output. It can be activated
in Alarm management settings, chapter
Advanced Configuration .
It may be used for instance to switch on the Fan kit when the
preset maximum internal temperature is exceeded or to inform
the connected RTU about a RipEX alarm or about the Unit ready
status. If an alarm is triggered, HW ALARM OUTPUT is internally
connected to GND. If the external device requires connection to
positive terminal of the power supply, PIN 4 should be used.
POWER
45 © RACOM s.r.o. – RipEX Radio modem & Router
Product