Raco AlarmAgent.com AA-102DC, Руководство по установке

Страница: 16 / 43

15
T
EMPLATE
R
IGHT OF
DIP
SWITCH
G
REEN
A
PPLICATION
T
EMPLATE
#
AGREES WITH
DIP S
WITCH SETTING
O
UTPUT
R
ELAY
#1 A
BOVE
4
POINT
TS R
ED
R
ELAY
# 1
IS ACTIVATED
O
UTPUT
R
ELAY
#2
A
BOVE
4
POINT
TS R
ED
R
ELAY
#2
IS ACTIVATED
T
EST
C
ALL
LED D25
R
IGHT OF
T
EST
C
ALL
P
USHBUTTON
G
REEN
T
EST CALLS ARE ENABLED
Note
The digital inputs each have their own LED indicator directly above their respective
connection points. Each LED activates when the corresponding digital input is in
the CLOSED condition.
This allows checking of signal input wiring even at a pre-installation site.
First, put the RTU in the Disarmed state as described below. Then you can manipulate the input signal
sources to verify that when those input signal sources are closed, the corresponding LED on the circuit
board is activated.
11.0 Armed and Disarmed States
Normally the RTU should be left in the Armed state (LED shows Green) so that it can send transmissions
to the web site when alarm conditions occur.
If you wish to prevent alarm transmissions temporarily, place the RTU in Disarmed state (LED flashes
Red). This should be done for example when you are performing maintenance at the RTU site and wish
to prevent false alarms.
While in the Disarmed state, scheduled report transmissions will still be sent.
Be sure to check the Armed/Disarmed state before leaving the site.