3156B User Manual
Using the Instrument 3-28
Racal Instrument © 2005
The sequence generator goes through its steps in descending order.
In continuous run mode, the sequence is repeated automatically after
the last step has been completed. When the generator is set to
operate in Triggered mode, the output stops at the last point of the last
waveform in the sequence. In Gated mode, the sequence is always
completed after the gate stop signal.
If a mistake is made and removal of one or more steps from the
sequence table is needed, use the following command:
ri3156B_delete_sequence_step (n)
where <n> is the step number to be removed from table. To delete the
entire sequence table and start from fresh use the following function
call:
ri3156B_delete_sequence_step (0)
where the variable <0> defines a delete all segments command
CAUTION
The above command is destructive to the sequence table.
Once executed, there is no restore procedure.
Содержание 3156B
