-5-
5. Operating your pressure washer
5.1 Connection of high pressure hose
5.1.1. Mount the high pressure hose on the outlet.
5.2 Mounting of spray lance, nozzles and foam
sprayer
5.2.1. Push the spray lance (8) into the spray gun
(10) and screw it on.
5.3 Water connection
An ordinary 1/2” garden
hose of
min. 5 m
and
max. 25 m
will be suitable.
NOTE:
Connection to the public mains
according to regulations.
5.3.1. Let the water run through the water hose
before connecting it to the machine to
prevent sand and dirt from penetrating the
machine.
Note:
Check that the filter is fitted in the water inlet
pipe and that it is not clogged up.
5.3.2. Connect the water hose to the water
supply by means of the quick connector
(inlet water, max. pressure: 0.7MPa, max.
temperature: 40°C).
5.3.3. Turn on the water.
5.4 Start and stop of the machine
The spray lance is affected by a thrust during
operation
therefore always hold it firmly with both hands.
-
IMPORTANT:
Point the nozzle at the ground.
I. Check that the machine is in horizontal
position.
NOTE:
Do not place the machine in high grass!
II. Release the trigger lock.
III. Activate the trigger of the spray gun and let
the water run until all air has escaped from the
water hose.
IV. Press the Start/stop switch “
I
” .
V. Activate the trigger of the spray gun.
Always adjust the distance and thus the
pressure of the nozzle to the surface, which is
to be cleaned.
Do not cover the machine during operation or
use it in a room without adequate ventilation!
Note:
If the machine is left or not used
for 5 minutes, it must be switched off
on the start/stop switch “
O
” :
I. Press the start/stop switch “
O
”.
II. Disconnect the electrical plug from the socket.
III. Shut off the water supply and activate the
trigger to relieve the machine of pressure.
IV. Lock the spray gun.
When releasing the trigger of the spray gun,
the machine automatically stops. The machine
will start again when you reactivate the spray
gun.
