RabbitCore RCM2100, Руководство по началу работы

Страница: 16 / 47

12 RabbitCore RCM2100
2.3.1 Attach Module to Prototyping Board
Turn the RCM2100 module so that the Ethernet connector is on the left, as shown in Figure 4
below. Align the module headers J1 and J2 into sockets J1 and J3 on the Prototyping Board.
Figure 4. Installing the RCM2100 Module on the Prototyping Board.
Note the orientation of the module.
NOTE: It is important that you line up the RCM2100 pins on headers J1 and J2 exactly
with the corresponding pins of headers J1 and J3 on the Prototyping Board. The header
pins may become bent or damaged if the pin alignment is offset, and the module will
not work.
Press the module’s pins firmly into the Prototyping Board headers. The installed module is
shown in Figure 5 below.
Figure 5. RCM2100 Installed and Seated on the Prototyping Board