RabbitCore RCM2000 Series, Руководство по началу работы

Страница: 27 / 46

Getting Started 23
4. U
SING THE
TCP/IP F
EATURES
4.1 TCP/IP Connections
Before proceeding you will need to have the following items.
•
If you don’t have Ethernet access, you will need at least a 10Base-T Ethernet card
(available from your favorite computer supplier) installed in a PC.
•
Two RJ-45 straight through Ethernet cables and a hub, or an RJ-45 crossover Ethernet
cable.
The Ethernet cables and Ethernet hub are available from Z-World in a TCP/IP tool kit.
More information is available at www.zworld.com.
1. Connect the AC adapter and the programming cable as shown in Chapter 2, “Hardware
Setup.”
2. Ethernet Connections
If you do not have access to an Ethernet network, use a crossover Ethernet cable to con-
nect the RCM2200 board to a PC with at least a 10Base-T Ethernet card.
If you have Ethernet access, use a straight Ethernet cable to establish an Ethernet con-
nection to the RCM2200 from an Ethernet hub.
The PC running Dynamic C through the serial port on the RCM2200 does not need to
be the PC with the Ethernet card.
3. Apply Power
Plug in the AC adapter. The RCM2200 is now ready to be used.