RabbitCore eDisplay OP7200, Руководство пользователя

Страница: 123 / 174

User’s Manual 117
5.2.3 Run the
PINGME.C
Demo
Connect the crossover cable from your computer’s Ethernet port to the OP7200’s RJ-45
Ethernet connector. Open this sample program from the
SAMPLES\TCPIP\ICMP
folder,
compile the program, and start it running under Dynamic C. When the program starts run-
ning, the green
LNK light on the OP7200 should be on to indicate an Ethernet connection
is made. (Note: If the LNK light does not light, you may not have a crossover cable, or if
you are using a hub perhaps the power is off on the hub.)
The next step is to ping the board from your PC. This can be done by bringing up the MS-
DOS window and running the ping program:
ping 10.10.6.100
or by Start > Run
and typing the command
ping 10.10.6.100
Notice that the orange ACT light flashes on the OP7200 while the ping is taking place, and
indicates the transfer of data. The ping routine will ping the board four times and write a
summary message on the screen describing the operation.