R2 TST Series, Инструкция по эксплуатации и техническому обслуживанию, Страница: 11 / 20

11 - Maintenance
(*note 8 mod. hi)
Operations to be carried out in order to maintain the machine in good working conditions:
- Before using the machine:
1. Check the screws tightening of the three-point linkage frame and the good state of repair of the
pins and the safety pins of the connection arms.
2. Check that the screws are tight, in particular check that the hoes screws are intact, if while
working they break, it is necessary to stop working and replace them.
- Regularly:
1. Lubricate the universal joint spider (Fig. 13 – Ref. A) and the other cardan elements as
indicated in the instruction booklet, through the greasers.
2. Lubricate the universal joint (Fig. 14-Ref. A) and the forks (Fig. 14-Ref. B) of the double joint
transmission each 50 working hours :
- At the beginning of the working season and each 4 months:
1. Check the level of the lubricant oil in the gear-box through the transparent cap put on the gear
box side (Fig. 15 – Ref. A); the quantity of oil is enough if it is visible through the cap. If you
need to fill oil up,use the cap put on the upper part of the gear box (Fig. 15 – Ref. B).
2. Grease the roller supports (Fig. 16 - Ref. A).
3. Check the grease level in the chain guard using the specially provided cap (Fig. 17 – Ref. A);
During the maintenance operations wear protective gloves; for the lubrification/greasing
operations always wear nitrile gloves and protective glasses
If the maintenance is made on a raised plane (for example
on a workbench), always wear safety shoes. All the
maintenance work must be performed with the tractor off
and the key off.
Fig. 13 Fig. 14 Fig. 15
Fig. 16
Fig. 17
After finishing the lubrification /
greasing operations, clean the
residual of lubricant left on the
floor to avoid sliding.
A
A
A
B
B
B
A
A
ENGLISH
11
11