R.V.R. Elettronica URPR/ MIC, Руководство пользователя

Страница: 38 / 48

34
/ 42 User Manual Rev. 1.0 - 29/06/12
URPT/MIC & URPR/MIC
ELETTRONICA
6.3 Operation
1) Power on the receiver and ensure that the
ON
light turns on. Equipment
name should appear briefly on the display, quickly followed by the graphic
representation of the instantaneous modulation level and indication of received
signal (menu 1).
The vertical bars under “Mod” indicate the progress of the modulation in
real time; the hatched bar signals the maximum nominal modulation level at
75 kHz (100%).
The above line displays the instantaneous reading of the signal level received
on analog scale.
Menu 1
1b) To
modify RF level setting
, hold down the
ENTER
button until opening the
power setup menu
.
The edit screen will look like this:
Menu 2
The upper line is a reading of RF level, while the bottom line gives the instantaneous
reading of the muting level. Press button
to increase level, press to decrease
it. When you have achieved the desired level, press
ENTER to confirm and exit
the
default menu
. Please note that the setting is stored automatically; in other
words, if you press
ESC
or do not press any keys before the preset time times
out, the latest power level set will be retained.
2) Ensure that the equipment is not in a locked-out state. Press
ESC
to call up
the selection screen (menu 3). Highlight
Fnc
and press
ENTER to confirm and
access the selected menu (menu 4).
If
AF
is set to OFF, move cursor to
AF
. Press
ENTER
and label will switch to
ON.
Press
ESC
twice to go back to the default menu (menu 1).
3) Fine tune mute setting from menu 2 (see description of item 1b) until achieving
the desired value.
4) Check, again in the
Fnc
menu under
Tpy
, the set up on
Transm
; if it is set in
Repeat
position , please go with the cursor on that item. Press the
ENTER
key
to change the voice under
Transm
.