R.V.R. Elettronica PJ1000M-C, Руководство пользователя

Страница: 9 / 44

PJ2000M-C, PJ2500M-C & PJ3000M-C
5 / 40 User Manual Rev. 1.5 - 09/01/09
5. Quick installation and operating reference
The scope of this chapter is to summarize the procedures for installing the machine.
If any point is not fully comprehensible, such as how to operate the machine the
first time, it is advisable to read the entire manual very carefully.
In this description it is assumed that the amplifier is not supplied pre-installed in
a rack inside a transmission system. In this case most of the operations outlined
herein (for instance the wiring ones) are obviously not necessary.
5.1 Preparation
Unpack the amplifier and firstly check that it has not been damaged in any way
during transport. Make sure that all the connectors and controls on the front and
back panels are in good order.
Check the default setting of the type of power supply for this machine on the back
of the PS module, which may be:
• single-phase 208 V, +15% -10%
• single-phase 230 V, +10% -15%
• three-phase 208 V, +15% -10%
• three-phase 230 V, +10% -15%
• three-phase 400 V, +10% -15%
Suggestion : Specify the type of power supply at order placement: the machine
will be delivered to you configured according to your requirements.
Check, if need be, that the fuses are installed, in good working order and accessible
on the back panel of the PS module. The required fuse values are as follows:
@208/230V
single phase
@208/230V
three phase
@400V
three phase
AUX OUT FUSE
(chap. 6.2 – position [9])
(1x) F6,3T type
5x20
(1x) F6,3T type
5x20
(1x) F6,3T type
5x20
SERVICE FUSE
(chap. 6.2 – position [10])
(1x) F6,3T type
5x20
(1x) F6,3T type
5x20
(1x) F6,3T type
5x20
MAINS FUSE
PJ2500M-C e PJ2000M-C
(chap. 6.2 – position [1])
(3x) F25T type
10x38
(3x) F20T type
10x38
(3x) F16T type
10x38
MAINS FUSE
PJ3000M-C
(chap. 6.2 – position [1])
(3x) F32T type
10x38
(3x) F25T type
10x38
(3x) F16T type
10x38
Install the amplifier in a standard rack for 19” modules.
Assemble the modules by inserting them one on top of the other.
Make the connections between the PS module and the RF module using the cables
supplied with the machine: