8 / 32
User Manual
Rev. 1.0 - 20/06/08
PJ500C-LCD, PJ700C-LCD & PJ1000light
Figure 5.2:
Connection to exciter
5.2 First power-on and setup
Follow this procedure upon first power-on and after making changes to the
configuration of the transmitter in which the amplifier is integrated.
Note :
Standard factory settings are RF power output Off (
Pwr OFF
) and output
power set to upper limit (unless otherwise specified by customer).
5.1.2 Pilot exciter setup
Set up the pilot exciter so that the output power it delivers to a matched load equals
the maximum input power indicated in the amplifier
final test table
, switch off the
exciter and connect it to the amplifier.
5.2.2 Power-on
When you have performed all of the connections described in the previous
paragraph, power on the amplifier using the suitable power switch on the front
panel (figure 6.1). Power on the pilot exciter.
