R-Tech INV160, Руководство по эксплуатации

Страница: 11 / 18

11
Wire Spool Fitment
1. Wire reel retainer
Push and twist in, to retain wire roll adaptor onto wire reel
2. Roller tensioner
Do not over tighten wire feed pressure roller as this can cause premature motor and
roller failure.
Correct way to adjust tensioner is to slacken off pressure so that mig welding wire does
not feed, slowly adjust pressure until wire feeds smoothly, you should be able to stop
wire feeding by holding wire and it should slip on rollers.
If you have too little pressure wire will slip when welding causing unwanted Burnback
into tips
3. Wire Feed Drive Assy
Make sure rollers are correct size for wire diameter selected, to change roller size
release retaining screw, remove roller turn roller around and slide onto shaft making
sure the right size groove is in line with wire and refit retaining screw.
The INV160 comes fitted with a dual roller 0.6mm and 0.8mm
4. Wire reel adaptor
Remove the wire reel retainer and wire reel adaptor, slide on roll of wire and refit the
reel adaptor (This can be reversed to suit different manufacturer’s reel sizes)
Refit the wire reel retainer by pushing in and twisting so it locks in