- 6 -
weight, preventing it from being extended horizontally. If the 27cm length is sufficient to
reach most of your inspection targets, select that shorter length; at about 45cm the probe
is light enough to be extended horizontally. Whichever probe length you choose, you must
carefully un coil the unextended section of probe from the channel inside the tube slot. To
re -coil the probe, it’s important to note that when re-coiling the probe from either its short
or long extended length, you must wrap it very tightly within the channel. If the camera
head is not back to the original position as you finish wrapping the probe, you will not be
able to squeeze the camera head. You must start over.
THE FUNCTION OF THE PROBE TIP ACCESSORIES in V5555
The system comes with three accessories that screw onto the end of camera head. Take
off the protection ring before using the tip accessories.
Each accessory has a specific purpose:
The 45 ° mirror lets the probe see around corners.
The hook lets you retrieve inaccessible items seen by the camera probe; for example, a
wedding ring accidentally dropped down a sink drain.
The magnetic pickup lets you retrieve lost or dropped metal objects , like nuts and bolts .
OPERATING INSTRUCTIONS
QUICK START PROCEDURE
1. Before you use the device for the first time, carefully peel off and discard the plastic
film protecting the LCD.
2. Press and hold the
button for at least 3 seconds to power on the unit and illuminate
the LCD.
3. Point the camera-tipped end of the probe at the target, pushing the probe through holes
or bending the probe around objects if necessary. Avoid bending the delicate probe
excessively, this will damage it.
4. Press the
button to take picture.Long press the button to enter recording mode,
short press the button to begin recording, press again to stop recording.
5. Press the
button to still the picture, press the button again to release the picture,
