QVI Cobra DRS-2000, Руководство пользователя

Страница: 61 / 100

To create a profile by scanning a penny, follow the steps below.
1. Click on the Laser Home icon and then click on Yes i n response to the
prompt.
2. If necessary, click on the Laser Locator button to turn on the Laser
Locator. When turned on, the sensor emits a high intensity laser signal onto
the part and makes it easier to see the laser spot.
3. Position a penny under the sensor so that:
-
The Lincoln Memorial side of the penny is up.
-
A small red laser spot is displayed on the surface of the penny, near the
end of the Lincoln Memorial that is closest to the Cobra system.
4. Click the Laser Locator button to turn off the Laser Locator. This
activates the Laser Focus bar.
-
The Laser Focus bar is located on the left side of the Profile View,
below the Laser Locator button.
Note: The Laser Locator needs to be turned off before attempting to focus the
laser onto the part.
5. Twist the Focus knob to raise or lower the sensor to an approximate focus
distance above the penny.
6. Slowly twist the Focus knob to move the sensor in relation to the surface of
the penny, and observe the Laser Focus bar.
-
The sensor is focused when the Laser Focus bar is green with a red
horizontal bar in the middle of the Laser Focus bar.
On-line Help:
See the topic, How to Focus the Sensor , for more information on
focusing the sensor.
3-8 Getting Started