8.
If you purchased the Factory-supplied Computer option, unpack and set up
the computer and components at this time.
9.
Connect a parallel cable from the
PARALLEL PORT
on the Cobra back
panel (see Figure 2-3) to the parallel port on the associated computer.
10. Plug the female end of the supplied Cobra power cord into the power cord
receptacle on the back panel of Cobra (see Figure 2-3) and connect the male
end into a properly configured outlet.
11. If you did
not
purchase the Factory-supplied Computer option, install the
Scan-X software onto the associated computer (described later in this
section). It is pre-installed on computers purchased from the factory.
This completes the procedure for unpacking and setting up Cobra 2D.
Installation and Setup
2-5
Installation
and
Setup
Figure 2-3. Connecting the Cables
Содержание Cobra DRS-2000
