10. OPERATING
YOUR
TRANSMITTER
Your DC brushless motor is equipped with
an automatically learned type remote
control. There is no frequency switches on
the receiver or transmitter. The fan can
start to use once the pairing process is
done.
Operation Instructions
A. 1, 2, 3, 4, 5 and 6 buttons:
These six buttons are used to set the fan
speed as follows:
1= minimum speed
2= low speed
3= medium low speed
4= medium speed
5= medium high speed
6= high speed
B.
button:
This button turns the fan off.
C. The " " button:
The " " button turns the upper
light ON or OFF and also controls the
brightness setting. The " " button turns
the bottom light ON or OFF. Press and
hold the button to set the desired
brightness. The light key has an
auto-resume, it will stay at the same
brightness as the last time it was turned
off.
D. The " " button is used to set the
fan forward or reverse, press the button
forward (for warm weather) or reverse (for
cool weather).
NOTE:
To operate the reverse function on
this fan, press the reverse button while the
fan is running.
E. "DIM" and "ON/OFF" dip switch: (Fig.
22)
The "DIM" selection is the light dimmable
selection for LED light only . The
"ON/OFF" selection is the light on only
(no dimmable function).
Fig. 21
Fig. 22
0
2
1
4
3
6
5
Pairing Process
With the fan’s power off, restore power to
the fan. Press and hold “ ” button for
about 5 seconds and release. If optional
light kit is installed, the light kit will flash
twice and the signal light on the remote
control will come on when the button is
pressed. The fan has completed the
pairing process with the remote control
and is ready for use.
NOTE:
A single fan can be controlled
with as many as 3 remote controls in one
room. Every control will need to repeat
the pairing process based on instructions
above and all controls must be within 30
feet of the fan.
If a room has two fans installed, each fan
will need it’s own remote control. A
single control CAN NOT control more
than one fan. Each fan will need to go
through the pairing process individually.
While running the pairing process on the
first fan, turn power off to the second fan.
When finished the pairing process for the
first fan, turn the power off and restore
power to the second fan and run the
pairing process-
NOTE
the " " button
must be pressed within 60 seconds of
restoring power to the second fan.
NOTE:
If multiple fans are installed on
the same circuit, each fan must have it’s
own switch leg. Each fan and remote
control pair must have its own wire from
the control to the fan (the wire from the
control to the fan can NOT be shared).
There can NOT be a jumper wire running
from fan to fan.
The receiver provides the following
protective function:
1.
Lock position:
The DC motor has a
built-in safety against obstruction during
operation. The motor will be locked
operation and disconnect power after 30
seconds of interruption. Please remove
obstacles before re-set.
2.
Over 80W protection:
When the
receiver detects motor power
consumption which is greater than 80W,
the receiver power will be stopped and
operation will immediately discontinue.
Turn the receiver power on after 5
seconds.