Quirky ISO, Руководство пользователя

Страница: 6 / 18

ISO
|
6
SAFETY INFORMATION
READ AND SAVE THESE INSTRUCTIONS
Please read and understand the entire manual before attempting
to assemble, operate, or install the product.
• Always disconnect the power supply prior to servicing the fan,
motor, or junction box.
• Installation work must be carried out by a qualified person(s) in
accordance to all local and safety codes, including the rules for
fire-rated construction.
• Follow all local building, safety, and electrical codes as well
as NEC (National Electrical Code) and OSHA (Occupational
Safety and Health Act).
• Electric Service supply must be 120 volts, 60 hertz.
• This unit must be properly grounded.
• Do not bend or kink the power wires.
• Exercise care to not damage existing wiring when cutting
or drilling into walls or ceilings.
• Sufficient air supply is required for proper combustion
and exhaustion of gases through the chimney (flue),
or fuel burning equipment, to prevent back-drafting.
*See the standards of NFPA (National Fire Protection
Association) and ASHRAE (American Society for
Heating Refrigeration and Air Conditioning Engineers)
and the local building code authorities.
• WARNING – To reduce the risk of fire or electric shock – do
not use this fan with any solid state control device, such as a
remote control, dimmer switch, or certain timers. Mechanical
timers are not solid state devices.
• Do not install in a cooking area.
• CAUTION – For general ventilating use only – do not use to
exhaust hazardous or explosive vapors.
• Fans should always be vented to the exterior in compliance
with local codes.
• Do not install in a ceiling with insulation greater than R42.
• Ductwork should be installed in a straight line
with minimal bends.
• Ductwork size must be the same size as the discharge
and should not be reduced. Reducing the duct size may
increase fan noise.
• Prior to servicing or cleaning this unit, shut off power supply
at the panel and lock to prevent the power from being turned
on. If the panel cannot be locked, clearly mark the panel with a
warning tag to prevent the power from being turned on.
• Use this unit in the manner intended by the manufacturer.
• WARNING – TO REDUCE THE RISK OF FIRE, ELECTRIC
SHOCK, OR INJURY TO PERSONS, OBSERVE THE
FOLLOWING:
a) Use this unit only in the manner intended by the manufacturer.
If you have questions, contact the manufacturer.
b) Before servicing or cleaning unit, switch power off at service
panel and lock the service disconnecting means to prevent
power from being switched on accidentally. When the service
disconnecting means cannot be locked, securely fasten a
prominent warning device, such as a tag, to the service panel.
• If you have any questions please call customer service at
1-866-5QUIRKY (1-866-578-4759).