Quidway WB2011, Руководство пользователя

Страница: 115 / 157

Bridge Commands
6-35
6
Command Usage
This command sets the maximum time (in seconds) the root device will wait
before changing states (i.e., discarding to learning to forwarding). This delay is
required because every device must receive information about topology
changes before it starts to forward frames. In addition, each port needs time to
listen for conflicting information that would make it return to the discarding
state; otherwise, temporary data loops might result.
Example
bridge stp-bridge hello-time
Use this command to configure the spanning tree bridge hello time globally for the
wireless bridge. Use the
no form to restore the default.
Syntax
bridge stp-bridge hello-time time
no bridge stp-bridge hello-time
time - Time in seconds. (Range: 1-10 seconds).
The maximum value is the lower of 10 or [(max-age / 2) -1].
Default Setting
2 seconds
Command Mode
Global Configuration
Command Usage
This command sets the time interval (in seconds) at which the root device
transmits a configuration message.
Example
bridge stp-bridge max-age
Use this command to configure the spanning tree bridge maximum age globally for
the wireless bridge. Use the
no form to restore the default.
Syntax
bridge stp-bridge max-age seconds
no bridge stp-bridge max-age
seconds - Time in seconds. (Range: 6-40 seconds)
The minimum value is the higher of 6 or [2 x (hello-time + 1)].
The maximum value is the lower of 40 or [2 x (forward-time - 1)].
Outdoor Bridge(config)#bridge stp-bridge forward-time 20
Outdoor Bridge(config)#
Outdoor Bridge(config)#bridge stp-bridge hello-time 5
Outdoor Bridge(config)#