Quidway WB2011, Руководство пользователя

Страница: 114 / 157

Command Line Interface
6-34
6
bridge stp-bridge spanning-tree
Use this command to enable the Spanning Tree Protocol globally for the wireless
bridge. Use the
no form to disable it.
Syntax
bridge stp-bridge spanning-tree
no bridge stp-bridge spanning-tree
Default Setting
Spanning tree is enabled.
Command Mode
Global Configuration
Command Usage
The Spanning Tree Protocol (STP) can be used to detect and disable network
loops, and to provide backup links between switches, bridges or routers. This
allows the wireless bridge to interact with other bridging devices (that is, an
STP-compliant switch, bridge or router) in your network to ensure that only
one route exists between any two stations on the network, and provide backup
links which automatically take over when a primary link goes down.
Example
This example shows how to enable the Spanning Tree Protocol for the wireless
bridge:
bridge stp-bridge forward-time
Use this command to configure the spanning tree bridge forward time globally for the
wireless bridge. Use the
no form to restore the default.
Syntax
bridge stp-bridge forward-time seconds
no bridge stp-bridge forward-time
seconds - Time in seconds. (Range: 4 - 30 seconds)
The minimum value is the higher of 4 or [(max-age / 2) + 1].
Default Setting
15 seconds
Command Mode
Global Configuration
Outdoor Bridge(config)#bridge stp-bridge spanning-tree
Outdoor Bridge(config)#