Quicksilver 675WE, Руководство пользователя

Страница: 58 / 91

Quicksilver 675WE — Electrical Systems
46
Charge relay
Battery switch
Aft bilge breaker — 3 Amp
Forward bilge breaker — 3 Amp
Trim tab breaker — 15 Amp
Spare breaker — 10 Amp
Carbon monoxide breaker — 5 Amp
Tank monitor breaker — 3 Amp
Waste macerator breaker — 20 Amp
Grey water macerator breaker — 20 Amp
Helm main breaker — 60 Amp
Bow windlass breaker — 60 Amp
Waste macerator switch
Grey water macerator switch
Battery Panel
Panel Location
6. AC Electrical System (optional)
The AC electrical system allows you to use the following 230V appliances while docked and connected
to a shore power system:
1. Battery charger
2. Electrical outlets
The shore power receptacle is located on the port side of the salon house (exterior), while the AC
main panel is located on port aft corner of the salon. There is one 230V electrical outlet located on the
boat, located on the forward face of the aft dinette seat.
A 15m shore power cable with one plug end is also included. Before use, your authorized Quicksilver®
dealer will need to wire the correct plug (for use in your region) on the other end of the shore power
cable.
The 230V / 50Hz wiring consists of three color - coded wires. The brown wire is the “ hot ” feed, blue
wire is the common, or neutral, and the green wire is ground. The entire system is protected by a
Residual Current Device with Overcurrent Protection (RCBO), located on the AC panel. From there,
individual line circuits add additional protection of each appliance in the system.