Quicksilver 675WE, Руководство пользователя

Страница: 56 / 91

Quicksilver 675WE — Electrical Systems
44
1. DC Electrical System
The standard DC electrical system is powered by two batteries, and is kept charged by the engine
driven alternator or by the battery charger when connected to AC power. The battery voltage is
indicated by the voltmeter screen located on the SmartCraft
TM
tachometer, or on the optional GPS
with Vessel Link.
2. Batteries
Quicksilver® recommends AGM type starting or a deep cycle battery for you boat. The battery must
meet the minimum capacity required by the engine manufacturer. Refer to your engine owner
’ s
manual for exact battery requirements.
To remove the battery cables:
1. Turn off all items drawing power from the battery.
2. Turn the battery switches to the OFF position.
3. Remove the negative cable first, then the positive cable.
To replace the cables, install the positive cable first, then the negative cable.
3. Battery Boxes
The batteries are located in the aft bilge and can be accessed through the cockpit floor storage hatch.
They can be installed or removed by loosening the strap and removing the lid on the battery box. The
batteries should always be installed and secured within the battery boxes on your boat. This will
ensure that the battery will not move around while the boat is underway.
4. Battery Selector Switch
Your vessel is equipped with a battery switch to control the delivery of DC power from the batteries.
The battery switch are located on the starboard side of the cockpit behind an access door.
On your boat, there is one battery switch that controls two isolated battery banks. When you turn the
battery switch to the ON position, power is provided from both the port engine battery and the
starboard house battery. The battery switch also has the ability to combine battery banks for
emergency starting. To turn on power to the boat, rotate the switch clockwise 90 degrees to the ON
position. To utilize both battery banks for emergency starting, push the switch in and rotate clockwise
45 degrees.
Never use an open flame in the battery storage area. Avoid
striking sparks in the battery area.
Always disconnect the battery before doing any work on the
electrical system. Never turn off the battery switches or
disconnect the battery cables while the engines are running.
Battery Switch Operation
OFF Position ON Position Combine Batteries
NOTE: Never operate or turn off the battery switch when the engine is running as it may cause
damage to electronic components on the boat. Always operate the switch with the engine and
accessories off.