Quickie Nitrum, Инструкция по применению

Страница: 18 / 88

18
ENGLISH
Nitrum / Nitrum Hybrid Rev.C
1
3
6
2
5
9
7
4
Fig. 4.34
10
7
8
9
Fig. 4.35
9
10
9
Fig. 4.36
Fig. 4.37
7
Sideguards
Single Post Height-Adjustable Armrests (Fig. 4.34 - 4.37).
1. Assembly
a. slide the outer armpost into the receiver mounted to the
wheelchair frame.
b. the armrest will automatically lock into place.
2. Height adjustment
a. rotate height release lever (2) to second stop.
b. slide armrest pad up or down to desired height.
c. return lever to locked position against arm post.
d. push arm pad (4) until upper arm post locks firmly into
place.
3. Removing the armrest
a. pull lever 3 and lift entire arm.
4. Replacing Armrest
a. slide armrest back into receiver until arm latches in place.
Armrest Receiver Attachment
(Fig. 4.34 - 4.37).
Adjusting Armrest Receiver Fit
To tighten or loosen the fit of the outer armpost in the receiver:
1. Loosen the four receiver adjustment bolts (9) on the sides of
the receiver.
2. With the armrest in the receiver (7), squeeze the receiver to
achieve the desired fit.
3. Tighten the four bolts (9). (16.3 Nm)
Position Adjustment
1. Loosen the two clamp bolts (10) until clamp is loose.
2. Slide armrest receiver to desired position.
3. Tighten
Freestyle Back
The Freestyle back can be adjusted in height, depth and angle
to provide maximum comfort and support.
Height adjustment:
Remove the back cushion to gain access to the adjustment
hardware. Loosen the 4 screws (1) using a 4 mm hex key and
move the back shell up or down to the desired height. Tighten
the screws to lock the adjustment and re-install the back
cushion.
Fine Depth and Height adjustment
The Freestyle back adjustment system provides a maximum of
25 mm fine depth combined with a fine height adjustment .
Loosen the screws (2) using a 8 mm hex key and rotate the
back shell to the desired position. Tighten the screws with 20
Nm to lock the adjustment.
Angle adjustment
The Freeestyle back adjustment system allows the adjustment
of the backrest angle. Loosen the screws (3) using a 8 mm hex
key and rotate the back shell to the desired position. Tighten the
screws with 20 Nm to lock the adjustment.
In case some attendant support is required the removable push
handles can be screwed into position A.
WARNING!
Always make sure that the push handles are screwed in
completely.
WARNING!
The Freestyle back is not approved for using the wheelchair as
a seat in a car during transport.
1
Fig. 4.30
1
Fig. 4.31
3
2
Fig. 4.32
A
Fig. 4.33
20 Nm
20 Nm
Fig. 4.34 - 4.37 Parts key
1. Outer armpost 6. Sideguard
2. Height Release Lever 7. Receiver
3. Release lever 8. Clamp
4. Armrest Pad 9. Receiver adjustment bolts
5. Transfer bar 10. Clamp bolts