2
device.
While the procedure paused, must inspect before manual operation.
Before starting the operation, make sure that there is no person or obstacle in the
robot’s working area.
Avoid falling the fittings or having an accident, please take the device and fittings
by help.
Mind head! Attention about the sheet metal.
Carry to an applicable place, install the device on a flat floor.
The product must be used or stored in an applicable environment.
Working ambient temperature is 0~40
℃
, relative humidity is 20%~90%.
The equipment is heavy and huge, do not pile up.
Before moving and carrying, make sure the movements is fixed (for example the
X-axis may be fixed by sheet metal or lines for safety).
Unfold the packaging, before using the robot, make sure the movements’ fixture
(for example the X-axis may be fixed by sheet metal or lines for safety) was taken
down.
Install the robot firmly so that it will not be shaken.
Regularly inspect and maintain will increase durability and performance.
Must operate the robot by standard procedure.
Before starting a repetitive operation, make sure that no obstacle is in the robot’s
working area.
Please use robot within the standard requirements (such as voltage, air pressure,
power frequency) as stated in the specification.
Make sure the air source is clean and dry.
Suggest the air pressure is less than 0.7Mpa.
Attention
Do not throw the packaging and foamed plastic.
If the robot should come back to the manufacture, it must be folded by initial.
The robot must be placed vertically.
The robot can be packet after fold by foamed plastic.
The robot can’t get wet
1.2 Unpacking and inspection
1.Carton packing
：