EN
.
The installation process, tested and approved by professional electricians, consists of the
following simple steps:
1.
To prevent electrical shock and/or equipment damage, disconnect electrical power at
the main fuse or circuit breaker before installation and maintenance.
2.
Be aware that even if the circuit breaker is off, some voltage may remain in the wires —
before proceeding with the installation, be sure no voltage is present in the wiring.
3.
Take extra precautions to avoid accidentally turning on the device during installation.
4.
Connect the module exactly according to the diagram.
5.
Place the antenna as far as possible from metal elements as they may cause signal
interference.
6.
Do not shorten the antenna.
The module’s antenna should be as upright as possible. This way the Z-wave operational range
can be wider (up to 30m indoors (98ft)).
