QubicaAMF Harmony, Инструкция по установке, эксплуатации, обслуживанию и каталог запасных частей

Страница: 22 / 72

I
NSTALLATION
Harmony Ball Return Manual – 400-254-022
12
Rev. Date 3/16
6.5 INSTALLING THE HOOD ASSEMBLY
Figure 7, Harmony Hood Assembly
1. Place the floor plate templates on the approach around the lift so that you can read the
“EVN” and “ODD” labeling.
2. Fit template halves together and center on lift.
3. Once in place, drill through one hole into the approach and pin the template with a 3/16”
diameter screw or another 3/16” drill bit. Repeat on the opposite side. Then drill the
remaining holes. Remove the template.
4. Install the hood locking pins (254-001-014) to the holes in the side of the rack-bezel support
as shown in Figure 8.
5. Install the rack-bezel support (in the orientation shown in Figures 8 and 10) on the rack side
of the ball lift using four self-tapping screws (821-142-202) into the pre-drilled holes.
6. Install the rails and the front floor bracket to the floor using eight (8) flat-head Phillips
screws (829-642-202) as shown in Figure 8.
7. Fasten the floor rail tab to the rack-bezel support as shown in Figures 8 and 10. Ensure that
the face of the rack-bezel support is plumb.
8. Install the hood retaining bracket on the two studs of the front floor bracket followed by
two washers (948-753-102) and two nuts (838-549-002).
Blower
Hood
Access
Panel
Bezel
Rack-Bezel
Support