Install the Isolation Switch (29) between the battery and the Control Unit on the positive (+) cable, use two of the 8mm Battery
Terminal Connectors (22) to link the cable to the switch terminals. Nuts and bolts are provided to mount the switch but please
substitute as necessary if they are not of a suitable type. Again, it is recommended to use the supplied Trunking (11) to protect the
cables against sharp edges. Attach the trunking with P-Clips (20) and P-Clip Screws (19).
Connect the Battery Cables to the existing battery terminals (red = positive, black = negative). Two types of Battery Terminal
Connector (22 & 23) are provided for use as appropriate.
Caution! Make sure that you do not reverse the Positive (+) and Negative (-) connections. Incorrect connection (reverse polarity) will
result in damage to the control box.
The length of wiring from one motor and the other must always remain the same, this will prevent a performance difference (due
to voltage drops) from one side to the other.. Fix the spade connectors using crimping pliers. A secure and good quality connection
on each cable is essential.
Finally, connect the Battery Cables (14 & 15) to the Control Unit (1). Installation of your Caravan Mover is now complete.
Before use, always check the mover for any damage.
When towing or moving the caravan please be aware, at all times, that ground clearance is reduced by 50mm
when the Mover has been fitted.
To maintain signal strength, always make sure that, during manoeuvring, the distance between the remote
control and the caravan does not exceed 5 metres.
DO be aware that the mover increases your caravan or trailer weight. So this reduces the payload of the
caravan.
DO always make sure that the rollers are fully disengaged from the tyres when the mover is not in use. This is
better for the tyres and for the mover.
DO always make sure that the rollers are fully disengaged before towing/moving the caravan by vehicle or
manpower. This can damage the tyres, mover and the towing vehicle.
DO
always make sure that after you have finished using the Mover, the Battery Power Isolation Switch (29) is
switched off and the key is removed and stored in a safe place (out of reach of children or other
unauthorised people).
DO always make sure that the remote control is stored in a safe place (out of reach of children or other
unauthorised people).
DO always apply the handbrake after manoeuvring, before disengaging the drive rollers from the tyres.
DO always ensure that children and pets are kept well out of the way during operation.
DO NOT rely on the mover to act as a brake.
DO NOT exceed the total Safe Working Load (SWL).
DO NOT
make any modifications on the caravan mover (mechanical or electronically). This can be very
dangerous! No warranty claim will be accepted and we cannot guarantee the function of the mover if any
modifications are made. We will not be liable for any damage whatsoever caused as a result of incorrect
installation, operation or modification.
The mover has two Motor Units (Installation Manual 1 & 2). In general they are mounted in front of the axle of the caravan/trailer.
Both units are identical, so either can fitted to nearside or offside framework. Please refer to appropriate Quattro500 or Quattro600
installation manual that is packaged in with your mover framework.
Operation - Safety Guidelines
Page 4
Operation - First Use
Page 5
QUATTRO500_ELECTRONICS_UM.indd 6
15/08/2019 16:47:53
