Positive Wire
Negative Wire
Page 10
AWD - Setup
Refer to the table below and Fig.4 and Fig.5 to wire the AWD system correctly. Note that if any part of the system is wired
incorrectly it could cause damage to the movers or caravan tyres if all rollers do not move in the correct directions.
WARNING: EACH CONTROL BOX MUST BE POWERED INDEPENDENTLY FROM THE BATTERY THROUGH THE SAME
ISOLATION SWITCH (TWO POSITIVE AND TWO NEGATIVE WIRES). CONNECTING THE BOXES DIRECTLY (PIGGY BACKING)
WILL OVERLOAD THE SYSTEM AND WILL DAMAGE THE SYSTEM.
1. Ensure that the motors are disengaged from the caravan wheels. Wire mover system as per tables above referring to Fig.4 and
Fig.5. Do not yet connect the link cable into Fig.4/Fig.5 socket E.
2. Ensure that the handset is first paired to the front axle to ensure this operates as the master. To do this disconnect the negative
wire from the rear axle control box ensuring that the negative wire is clear of any metal components.
3. Turn on the isolation switch to supply power to the front axle control box.
4. Power on handset by double-pressing button Fig.1C on the handset.
5. Set the handset to AWD mode by refering to the “setup and pairing” section on page 6.
6. Pair the handset to the front axle control box by refering to the “setup and pairing” section on page 6.
7. Power off the handset by double-pressing button Fig.1C on the handset.
8. Turn off the caravan isolation key to cut power to the mover.
9. Reconnect negative cable on the rear axle control box.
10. Connect the link cable into port E on both control boxes.
11.Power on system and ensure that all wheels are rotating in the correct direction.
Motor A Positive (+) cable to terminal M2+
Motor A Negative (-) cable to terminal M2-
Motor B Positive (+) cable to terminal M3+
Motor B Negative (-) cable to terminal M3-
AWD - REAR AXLE FITTING
Motor A Positive (+) cable to terminal M3+
Motor A Negative (-) cable to terminal M3-
Motor B Positive (+) cable to terminal M2+
Motor B Negative (-) cable to terminal M2-
AWD - FRONT AXLE FITTING
Table . B
Table . A
QUATTRO500_ELECTRONICS_UM.indd 13
15/08/2019 16:47:54
