Quatro Premium iVAC Series, Руководство по эксплуатации и обслуживанию

Страница: 12 / 29

© Quatro Air Technologies| MAY 2019 | All rights reserved |
iVAC Premium Series Operation and Maintenence Manual
Page 12
Controls
Light
(LED)
Status Audible
Alert
Condition Description/Action
F
ilter
C leaning
S ystem
LED 4 (L4)
Flashing
Slowly
Online Cleaning Mode During Operation Unit Will Stop For 15 Seconds To Clean Filter And Then
Resume Operation
See "Filter Service and Replacement" on page 15
Flashing
Quickly
Filter Being Cleaned See "Filter Service and Replacement" on page 15
SOLID FCS Motor Service Life
Expired
See "Filter Service and Replacement" on page 15
SOLID FCS Alarm Muted
L1 Flashing Slowly
Replace FCS Motor ASAP And RESET ALERT
Alarm Mute Details On Previous Page
See "Filter Service and Replacement" on page 15
Remote
Standby
LED 5 (L5)
SOLID Receiving Remote Signal Remote Switch Closed (On) OR Receiving Remote Signal From Another
Piece Of Equipment OR Mc2 Remote Function (If Equipped)
Fading
IN-OUT
Shutdown Delay QUATRO System Continues To Run For A Short Period To Remove All
Debris From Work Area
Flashing
Slowly
Unit Is In Standby Waiting For Remote Switch To Close (Turn On) OR To Receiving Remote
Signal From Another Piece Of Equipment OR Mc2 Remote Function (If
Equipped)
ALL LEDS Flashing
Slowly
Beep Every
Second
* Low System Pressure Abnormally Low Pressure, Unit will BEEP & Shutdown In 5 Seconds
Unit Will Continue To Shutdown Unit Until The Issue Is Addressed
-Motor(s) Not Operating Due To Service Required Or Failure
See
"
Motor Service and Replacement
" on page 23
-Motors Not
Operating Due To Excess Heat.
See
" Filter Service and Replacement" on page 15
-Access Door(s)
Open. Close All Access Doors
-Filters Not Or Improperly Installed. Verify Filters
** If SYSTEM ON LED is SOLID, but unit NOT operating,
Motor Not Operating Due To Service Required Or Failure, See "Motor Service and
Replacement" on page 23 For More Motor Info & Reset Alert Instructions .
Normal (Manual) Operation
Manual operation of the unit is accomplished by using the (Red) POWER button.
Variable Digital Speed Control and AUTOFLOW
Speed control is available in all modes of operation (manual and automatic) and is adjusted with the UP and DOWN
arrows.
AUTOFLOW is an automatic system pressure compensation system. After setting the minimum speed required to
properly evacuate your equipment, the controls will automatically increase the motor speed to compensate for the
increased pressure as a result of filters getting dirty or a system blockage until maximum speed is reached. After a
filter change, system will automatically decrease the speed to the original set point. Please verify that you are achieving
adequate ventilation after a filter change. If not adjust blower speed.