Quantum Quantum ValueLoader, Руководство пользователя

Страница: 28 / 90

Chapter 1 Installing the ValueLoader
Preparing the Host and Verifying the Connection
14 ValueLoader LTO-1/LTO-2 Tape Autoloader User Manual
6 Plug the power cable into the nearest properly grounded power
outlet.
7 Plug in the host server or workstation and all attached devices.
8 Turn on the ValueLoader by setting the power switch on the front
panel to the ON position. Turn on any other devices you turned off
earlier. Check the LCD screen to make sure the ValueLoader is
receiving power. If it is not, check the power connectors and the
power source.
During the Power-on Self Test (POST), all four LEDs are illuminated
briefly, followed by just the Ready/Activity LED flashing. When the
initialization sequence is complete, the LCD screen displays the
Home screen.
9 Turn on the server.
Preparing the Host and Verifying the Connection
1
If necessary, install a SCSI host adapter, software, and compatible
driver(s). Refer to the manuals for the host computer and the SCSI host
adapter for detailed instructions. In addition, follow these general
guidelines:
• When the host server is powered on, install software, and/or
driver(s) that are compatible with the ValueLoader (see Installing the
Device Drivers on page 15). Software compatibility information is
available at
www.Quantum.com
. Most backup software packages
require an additional module to communicate with the ValueLoader
robotics.
• If the host server is connected to a network, check with the system
administrator before turning off power.
• Use proper procedures to prevent electrostatic discharge (ESD). Use
wrist-grounding straps and anti-static mats when handling internal
components.
Note: To disconnect all power from the ValueLoader, remove the
power cable from the outlet.