16
CONNECTION OF REMOTE CONTROLLER WIRING
TO THE WATER HEATER
1.
Turn off the power supply to the water heater.
2.
Remove the front cover from the water heater. There are 3 screws on the front cover.
3.
Put the remote wires through the hole on the bottom of the unit’s casing.
4.
Remove the plastic cover and connect the remote control wires to the remote terminals directly.
(There is no polarity in the terminations.)
*DO NOT jump or short-circuit wires as it will damage the computer.
5.
Replace the plastic cover and the front cover. Then connect the power plug.
1 2 3 4 5 6 7 8
P L A S T I C
C O V E R
R E M O T E C O N T R O L
C A B L E
R E M O T E C O N T R O L
T E R M I N A L
R E M O V E T H E P L A S T I C C O V E R
A N D C O N N E C T T O T E R M I N A L S
D I R E C T L Y B E H I N D T H E C O V E R
REMOTE CONTROLLER – CABLE CONNECTIONS
1 2 3 4 5 6 7 8
MAIN
SHOWER
ENSUITE
TYPICAL CABLE LAYOUT
Put the remote wires through the
hole on the bottom of the unit’s
casing.