15
Connector base
WARNING
• DO NOT locate the remote controls where they may come into contact with water.
• DO NOT position the remote controls in the vicinity of chemicals.
• DO NOT position the remote controls over a cooker, grill or toaster.
• DO NOT position the remote controls where materials may spill onto them.
•
PLEASE NOTE IF THE CONTROLS ARE TO BE FITTED TO A METAL SURFACE, AN INSULATION
PLATE SHOULD BE PROVIDED BEHIND THE MOUNTING POSITION.
REMOTE CONTROLLER INSTALLATION
1.
Crimp the fork terminals to the wires.
• Minimum 18AWG wire (No polarity)
• Maximum 100m long
2. ATTACH THE FORK TERMINAL TO THE CONNECTOR BASE AT
THE BACK OF THE UNIT BY TIGHTENING THE 2 SCREWS.
3.
Draw the cable through the groove in the base plate.
4.
Fix the remote control to the wall using suitable screws and
wall anchors.
5.
Connect the cable to the two terminals on the back
of the controller (connections are not polarity sensitive).
Ensure the connecting screws are seated tightly.
Use the fork terminals
25 mm
45 mm
REMOTE CONTROL WIRING
83.5 mm
