Quantum PX720 Unpacking and Installation Instructions
Document 6444602-04 A01
March 2005
Installing the Quantum PX720 Library
27
3
Connect the host computers to the tape drives by routing SCSI cables up
through the base of the library and along the right-hand side of the
cabinet (see
figure 26
).
Figure 26 Connecting the
Tape Drives
4
Route an Ethernet cable up through the base of the library and connect
the front Ethernet port located on the right side of the cabinet controller to
the local network (see
figure 27
).
Tech Tip:
Start cabling with drive cluster 0 at the top of the library
and work down.
Note:
Make sure that all SCSI cables droop down slightly to ensure
that the back door closes.
Host computers
SCSI cables
Host computers
Cluster with 2 tape drives
per bus
Terminators
Host computers
Cluster with 1 tape drives
per bus
Terminators
Terminators
Host computers
