Quantum PX500 Series, Руководство пользователя

Страница: 61 / 294

Chapter 1 Library Description
Getting Started
Quantum PX500 Series User’s Guide 38
Cabling the Quantum
PX500 Series
1
After the Quantum PX500 Series is in its final location, the tape drives
and system controller board must be connected to the backup host
system(s).
To cable the Quantum PX500 Series:
1 The PX500 Series tape drives and system controller board are
accessed from the back of the library (refer to “Connecting to Host
Workstations” on page 51).
2 Connect Ethernet port located on the back of the library on the
system controller board to the local area network (see figure 18 ).
Figure 18 Connecting the
Library to the Local Area
Network
Loading Tape Cartridges
1
Before operating the library, load the appropriate tape cartridges (LTO or
SDLT) into the library starting with the left-hand panels (see “Library
Models” on page 2 for slot locations).
Warning: If the rack is empty at the time of installation, do NOT
install the PX-Series modules too high in the rack. The
combined weight of the components may cause the rack
to become “top heavy” and unstable if installed in the top
of an empty rack. If installing a multiple library stack,
begin installing the bottom library module first.
Ethernet port
System controller board
PX502 shown