Quantum LTO-8 HH SAS, Техническое справочное руководство

Страница: 65 / 126

Chapter 4: Operations
Diagnostic and Maintenance Functions
QuantumLTO-8 HH SAS User’s Guide 57
and Messages . The tape drive then unloads the FUP tape, and
exits Maintenance Mode after the cartridge is removed.
Function Code 9:
Display Error Code Log
Function Code 9 displays the last ten error codes, one at a time (the
codes are ordered; the most recent is presented first and the oldest is
presented last). If there are no errors in the log, function code
0 displays
in the Single-character Display (SCD) and exits Maintenance Mode.
1 Place the drive in Maintenance Mode. For instructions, see Entering
Maintenance Mode on page 48.
2 Press the Unload button once per second until 9 appears in the
SCD. (If you cycle past the desired code, press the Unload button
once per second until the code reappears.)
3 Press the Unload button, then release it to view the most recent
error code.
4 Press and release the Unload button again to view successive error
codes. Let two to three seconds pass between each depression. The
Ready light and Fault light will flash On/Off once for each
successive error code. The SCD will display 0 when all the error
codes have been displayed.
5 After viewing all error codes, exit this function by pressing the
Unload button again. The SCD will display 0 and exit Maintenance
Mode.
Function Code A: Clear
Error Code Log
Function Code A erases the contents of the error code log.
1 Place the drive in Maintenance Mode. For instructions, see Entering
Maintenance Mode on page 48.
2 Press the Unload button once per second until A appears in the
SCD. (If you cycle past the desired code, press the Unload button
once per second until the code reappears.)
3 Press and hold the Unload button for three or more seconds, then
release it to select the function. A flashes in the SCD, followed by 0 .
The tape drive erases all errors from the error code log and exits
Maintenance Mode.