Manual for KuDoz 7 series
Parallel Port, Serial Port Connectors ( UART1, UART2 )
The parallel port connector can be connected to a parallel device such as a printer. The serial
ports UART1,2 connectors can be connected to serial port devices such as serial port
mouses. You can enable/disable them and choose the IRQ or I/O address in “INTEGRATED
PERIPHERALS” from AWARD BIOS SETUP.
Line-in jack, Microphone-in jack, Speaker-out jack and MIDI/Joy-
stick Connector( Available on KuDoz 7-A/-C )
The Line-in jack can be connected to devices such as a cassette or minidisc player for
playback or recording. The Microphone-in jack can be connected to a microphone for voice
input. The Speaker-out jack allows you to connect to speakers or headphones for audio
output from the internal amplifier.
The MIDI/Joystick connector allows you to connect a game joystick or a MIDI device.
Note: For the KuDoz 7-C motherboard, the rear out jack replaces Line-in jack to
connect powered speakers for audio output.
Installation Instruction
ATX Power Supply Connector & Power Switch ( POWER SW )
Be sure to connect the power supply plug to this connector in its proper orientation. The
power switch ( POWER SW ) should be connected to a momentary switch (power button).
When powering up your system, first turn on the mechanical switch of the power supply (
if one is provided ), then push once the power button. When powering off the system, you
needn’t turn off the mechanical switch, just
Push once
*
the power button.
Note: * If you change “soft-off by PWRBTN” from default “Instant-off” to “Delay 4
Sec” in the “POWER MANAGEMENT SETUP” section of the BIOS, the power button
should be pressed for more than 4 seconds before the system powers down.
Parallel Port
UART1
UART2
Optional
POWER SW
ATX Power Supply Connector
20
1
5V
5 V
-5V
GND
GND
PSON
-12V
3.3V
GND
12V
5VSB
5V
GND
3.3V
GND
5V
GND
PWOK
3.3V
GND
MIDI/Joystick
Speaker out
Line in
Microphone in
Optional