Manual for KuDoz 7 series
Installation Instruction
Advanced Communications Riser Slot ( ACR )
The ACR connector uses a standard connector that is reversed and offset. Legacy AMR card
can be plugged into the ACR slot and works without modification. ACR provides a common
architecture for analog modem, Ethernet, phoneline networking and so on. It supports legacy
AMR riser designs for modem and audio codecs.
Note:
For the KuDoz 7, the AMR card should be set as AMR Primary card to use only.
For the KuDoz 7-A, to avoid conflict, you should set the AMR card as Slave when
use onboard audio codec( AC97 Codec ) or set the AMR card as Primary and
jumpers JP1, JP2, JP3 as disabling onboard audio codec( AC97 Codec ) when use
the audio codec on the AMR card.
For the KuDoz 7-C, the PCI1 slot can only use Slave card, and the AMR card should
be set as AMR Primary card to use only.
Smart Card Reader Connector( SCR )
The SCR interface connector is the interface between the motherboard and the Smart Card.
The SCR is built in IT8705F I/O chip and includes a standard UART to control Smart Card
interface handshaking and then performs data transfers. The SCR can be used for a broad
range of applications in GSM, ID, pay TV, banking and so forth. It also provides a Smart Card
clock divider for those ICC ( Integrated Circuit Card ) without internal clocks. If use this
function, set “UART Mode Select” to SCR in the “INTEGRATED PERIPHERALS” section of the
BIOS and jumpers J5, J6 as SCR enabled.
SCRFET#
VCC
1
NC
SCRCLK
RFU1
GND
NC
LED
NC
SCRREST
RFU2
SCRIO
SCRPRES#
NC
SCR1
ACR Slot
