Initial Configuration
11
DXi4000
Figure 7 Cabling the DXi4000
Initial Configuration
Before the DXi4000 is operational, you must configure the system through the remote
management console. You must also configure your backup software.
Configuring the DXi4000 consists of four major steps. See the following subsections for
detailed instructions for completing each step:
1
Accessing the DXi4000, Remote Management Console
on page 12
2
Completing the Getting Started Wizard
on page 14
3
Connecting the Ethernet Cables
on page 21
4
Creating a Typical Backup Configuration
on page 22
Note:
You will need a computer and an Ethernet cable to complete the initial setup.
Note:
If you attempt to install multiple DXi4000 systems at the same time, an IP
address conflict can occur because each system is configured with the same
default IP address (10.1.1.1). To avoid this problem, install one system and
configure it to use a different IP address before you connect another system to
the network.
ST
1
3
2
1
2
Gb
2
Gb
1
2
3
4
5
Power cables
Service port (not
for customer use)
Not used
Back
iDRAC port (not
for customer use)
Содержание DXi4520
Страница 2: ......
Страница 19: ...Initial Configuration 17 DXi4000 Figure 14 Getting Started Wizard Network...
