Quantum DX-Series System Unpacking and Installation Instructions
Document 6513502-06 A01
October 2006
Configuring the DX-Series System
55
•
Configuring the SNMP Settings
•
Enabling Fibre Channel Compression
•
Saving the DX-Series Configuration File
•
Restarting the System
Turning On the DX-Series
System
0
The power on procedure differs depending on the DX-Series system (DX30 or
DX100). Refer to the following section to turn on the DX-Series system:
•
Turning on the DX30
•
Turning on the DX100
Turning on the DX30
0
The DX30 components must be turned on in the following order:
• DX-Series storage array(s)
• DX-Series controller
To turn on the DX-Series system:
1
Turn on both power switches on all DX-Series storage arrays (see
figure 48
).
Figure 48 DX-Series
Storage Array Power
Switches
Caution:
If you need to reconfigure the RAID sets on the storage arrays,
refer to the
Quantum DX-Series Field Service Manual
PN6513503. The RAID configuration MUST be set prior to
powering on the DX-Series system.
