Chapter 4 Troubleshooting
Host Bus Adapter Settings
Quantum DX-Series User’s Guide
109
9
Enter
1
for 1 Gig Fibre Channel HBAs or
2
for 2 Gig Fibre Channel
HBAs in the
New Value
edit box, check both the
Permanent
and
Global
check boxes, and click
Change
.
Q-Logic™ Fibre Channel
HBA
4
For the DX-Series system to communicate with the Q-Logic Fibre
Channel HBA, the card must be setup correctly.
To setup the Q-Logic Fibre Channel HBA:
1
Power on the host containing the Q-Logic HBA.
2
As the host boots, watch for the Q-Logic prompt that tells you to
press
<Control> Q
to enter the HBA setup utility.
3
Under
Configuration Settings
, select
Host Adapter Settings
.
4
Under
Host Adapter Settings
, set the frame size to
2048
.
5
Under
Extended Firmware Settings
, set the type of connection to
#2
loop preferred, otherwise point-to-point
.
Note:
The default setting is 0 for auto speed selection. This
setting should
NEVER
be used. This could cause the HBA
to fail to initialize.
Содержание DX100
Страница 1: ...4XDQWXP 6HULHV 4XDQWXP 6HULHV 6HULHV 8VHU V XLGH 8VHU V XLGH 8VHU V XLGH 8VHU V XLGH 8VHU V XLGH...
Страница 10: ...Figures Quantum DX Series User s Guide x Figure 76 DX Series Setup Menu 119...
Страница 158: ...Quantum DX Series User s Guide 139 W write protection 45 enabling disabling 46...
