Quantum 6000 XL
www.quantumrehab.com
23
I V . A S S E M B L Y
Figure 12. Remote Plus Controller Routed on a
Synergy Seat
WIRE TIES
Figure 13. Remote Plus Controller Routed on a
High-Back Seat
To install the seat:
1. Tilt the seat back and slide the rear extrusion onto the
rear trapeze bar. See figure 11.
2. Lower the front extrusion onto the front trapeze bar until
the seat locks into place.
3. Flip the seat latch safety down.
WARNING! Make sure the seat latch
safety is flipped down before using your
power chair.
4. Install the controller and route the cable to the back of
the power base. See figure 12 or 13.
5. Loosen the rear shroud fasteners and remove the rear
shroud. See figure 6.
6. Plug the controller connector into the power base. See
figure 7.
7. Replace the rear shroud and tighten the rear shroud fas-
teners. See figure 6.
8. Secure the controller cable to the armrest receiver with
wire ties. See figure 13.