Manual for KD7E/333 series
3Hot key for Recovery
There are 12 options, including NULL and F2~F12. Key F12 is default.
If NULL is selected, Restore interface can not be used with pressing hotkey. If you
select one key of the rest 11 options, you can enter Recover interface by pressing
the hotkey you setup during POST.
NOTE:
If the Backup hotkey and Recover hotkey have been set with the same key, the
default will be Backup hotkey.
Backup Function Introduction
press Backup Hotkey to enter Backup Interface during the POST(Power On Self
Test), then the follwing interface will appear. You can scroll the highlight bar to the
option you want to work with using arrow key. Press ENTER to confirm.
figure-3 Backup Interface
Hard Disk Selection Menu
If you installed the system with several
IDE hard disks, and you have pressed
the backup or restore hotkey during
POST, hard disk selection menu will
popup before you enter backup or
recovery interface, in which all of the
IDE hard disks installed on your system
will be listed. You can scroll the highlight
bar to the hard disk you want to work
with using arrow key. Press ENTER to
confirm, and the following operation will
be performed on the selected hard disk:
figure-2 Hard Disk Select
1
Backup Partition Table
2 Backup System Partition C:
3 Backup Whole Disk
4 Backup CMOS Setup
5 Free Backup Area
6 Exit Backup Menu
