Manual for KD7E/333 series
Installation Instruction
Advanced Communications Riser Slot (ACR)
The ACR connector uses a standard connector that is reversed and offset. Legacy AMR
card can be plugged into the ACR slot and works without modification. ACR provides a
common architecture for analog modem. It supports legacy AMR riser designs for modem
and audio codecs.
Note:
For the KuDoz 7E/333, the AMR card should be set as AMR Primary card to use
only.
For the KuDoz 7E/333-A, to avoid conflict, you should set the AMR card as Slave
when use onboard audio codec( AC97 Codec ) or set the AMR card as Primary
and jumpers JP1, JP2, JP3 as disabling onboard audio codec( AC97 Codec ) when
use the audio codec on the AMR card.
For the KuDoz 7E/333-C, the PCI1 slot can only use Slave card, and the AMR
card should be set as AMR Primary card to use only.
Smart Card Reader Connector(SCR)
The SCR interface connector is the interface between the motherboard and the Smart
Card.
The SCR is built in IT8705F I/O chip and includes a standard UART to control Smart Card
interface handshaking and then performs data transfers. The SCR can be used for a
broad range of applications in GSM, ID, pay TV, banking and so forth. It also provides a
Smart Card clock divider for those ICC ( Integrated Circuit Card ) without internal clocks. If
use this function, set UART Mode Select to SCR in the INTEGRATED PERIPHERALS
section of the BIOS and jumpers J5, J6 as SCR enabled.
ACR Slot
SCRFET#
VCC
1
NC
SCRCLK
RFU1
GND
NC
LED
NC
SCRREST
RFU2
SCRIO
SCRPRES#
NC
SCR1
