QUANTA STRATOS S210 Series S210-X12MS, Техническое руководство

Страница: 208 / 223

I
NSTALLATION AND
A
SSEMBLY
S
AFETY
I
NSTRUCTIONS
G
UIDELINES
8-2
After you have completed the six SAFETY steps above, you can remove the system covers. To do this:
1. Unlock and remove the padlock from the back of the system if a padlock has been installed.
2. Remove and save all screws from the covers.
3. Remove the cover(s).
A microprocessor and heat sink may be hot if the system has been running. Also, there may be sharp pins and
edges on some board and chassis parts. Contact should be made with care. Consider wearing protective gloves.
For proper cooling and airflow, always reinstall the chassis covers before turning on the system. Operating the
system without the covers in place can damage system parts. To install the covers:
1. Check first to make sure you have not left loose tools or parts inside the system.
2. Check that cables, add-in cards, and other components are properly installed.
3. Attach the covers to the chassis with the screws removed earlier, and tighten them firmly.
4. Insert and lock the padlock to the system to prevent unauthorized access inside the system.
5. Connect all external cables and the AC power cord(s) to the system.
Danger of explosion if the battery is incorrectly replaced. Replace only with the same or equivalent type
recommended by the equipment manufacturer. Dispose of used batteries according to manufacturer's instructions.