Quanta Computer QuantaMesh, Руководство пользователя

Страница: 880 / 1020

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | IP Multicast Commands 880
7.6.2.5 ipv6 pim bsr-border
Use this command to prevent bootstrap router (BSR) messages from being sent or received through an
interface or range of interfaces. Note that this command takes effect only when PIM-SM is enabled in the
Global mode.
Syntax
ipv6 pim bsr-border
no ipv6 pim bsr-border
no - Use this command to disable the interface from being the BSR border.
Default Setting
Disbaled
Command Mode
Interface Config
7.6.2.6 ipv6 pim bsr-candidate
This command is used to configure the router to announce its candidacy as a bootstrap router (BSR).
The argument <slot/port> corresponds to a physical routing interface or VLAN routing interface.
Syntax
ipv6 pim bsr-candidate interface {<slot/port> | vlan <vlan-id>} <hash-mask-length> [<priority>]
no ipv6 pim bsr-candidate interface {<slot/port> | vlan <vlan-id>}
<slot/port> - Interface number on this router from which the BSR address is derived, to make it a
candidate. This interface must be enabled with PIM..
<vlan-id> - VLAN ID. The range of VLAN ID is 1 to 4093.
<hash-mask-length> - BSR hash-mask length. The range of the mask is 0 to 128. The length of a
mask that is to be ANDed with the group address before the hash function is called. All groups with
the saem seed hash correspond to the same RP. For example, if this value was 24, only the first 24
bits of the group addresses matter. This allows you to get one RP for multiple groups.
<priority> - Priority of the candidate BSR. The range of the priority is 0 to 255. The BSR with the
larger priority is preferred. If the priority values are the same, the router with the larger IP address is
the BSR. The default value is 0.
no - This command is used to remove the configured PIM candidate BSR router.
Default Setting