Quanta Computer QuantaMesh, Руководство пользователя

Страница: 233 / 1020

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands 233
5.3.6 SNMP Trap Commands
5.3.6.1 snmp-server host <host-addr> traps
This command configures traps to be sent to the specified host.
Syntax
snmp-server host <host-addr> traps version {1 <community> | 2 <community> | 3 <username> [auth |
noauth | priv]} [filter <filtername>] [udp-port <1-65535>]
no snmp-server host <host-addr>
<host-addr> - The IPv4 or IPv6 address of the host to send the trap to.
<community> - Community string sent as part of the notification. The range is 1 to 20 characters.
version 1 - Sends SNMPv1 traps.
version 2 - Sends SNMPv2 traps.
version 3 - Sends SNMPv3 traps.
<username> - Username of SNMPv3.
auth - Enables authentication but not encryption.
noauth - No authentication or encryption. This is the default.
priv - Enables authentication and encryption.
<filtername> - The filter name to associate with this host. Filters can be used to specify which traps
aresent to this host. The range is 1 to 30 characters.
<udp-port> - The SNMP Trap receiver port. The default is port 162.
no - This command deletes trap receivers.
Default Setting
None
Command Mode
Global Config
5.3.6.2 show trapflags
This command displays trap conditions. Configure which traps the switch should generate by enabling or
disabling the trap condition. If a trap condition is enabled and the condition is detected, the switch's
SNMP agent sends the trap to all enabled trap receivers. The switch does not have to be reset to
implement the changes. Cold and warm start traps are always generated and cannot be disabled.
Syntax