Qualstar Q24, Инструкция по установке и эксплуатации

Страница: 24 / 103

Q24 Tape Library Installation and Operations Manual
© Copyright QUALSTAR 2014 15
4. Insert the power supply on the alignment rails and push it into the bay until it seats itself
against the back of the library.
5. Tighten the blue captive screws with your fingers to secure the power supply to the library.
2.12 Connecting the cables
2.12.1 Connecting the power cord
DANGER
High voltage ‐ Risk of electric shock

Use only approved power cords.

Observe local health and safety requirements and guidelines for
manual material handling.
WARNING
Usage of non ‐ approved power cords
‐ Risk of personal injury
‐ Risk of damage to devices
Before connecting a power cord to the library:

Ensure that the power cord meets individual country specific
safety standards.

Use a sufficient conductor current capacity (amps) to avoid
overheating the cord.
The manufacturer disclaims all liability in the event a
non ‐ manufacturer approved power cord is used.
To connect the power cord to the library:
1. Plug the female connector of the power cord into the power connector (AC connector) on the
rear panel of the power supply.
2. Plug the male connector into an appropriate electrical socket.
2.12.2 Connecting a Fibre Channel cable
NOTE
Use only cables specified for your LTO Fibre Channel tape drive.
Each FC tape drive has two FC ports.

Cable [Port A] only.

Configure [Port B] for <Auto Detect> on <Fibre Speed> and
<Port Type>.
To connect the FC cable to the tape drive:
1. Remove the FC port caps if necessary. Attach one end of the FC cable to [Port A] on the tape
drive.